# Its chopper time! **URL:** \ **Category:** PittSpeed Automotive\ **Created:** [April 7, 2007, 1:06pm UTC](https://forums.speedlife.net/t/its-chopper-time/189095 "2007-04-07T13:06:33Z")\ **Posts on this page:** 1\ **Showing post:** 44
**Author:** ![obi-1](https://avatars.discourse-cdn.com/v4/letter/o/ac8455/32.png) [@obi-1](https://forums.speedlife.net/u/obi-1)\ **Post date:** [June 18, 2008, 6:19am UTC](https://forums.speedlife.net/t/its-chopper-time/189095/44 "2008-06-18T06:19:01Z")
> [@Send a message from optimus prime](https://forums.speedlife.net/t/send-a-message-from-optimus-prime/36871/4): > > One another good note. The bearings from the buell wheels are the same O.D. as the harley bearings. They went right in my new wheel so I don’t have to find another axle and modify the frame for it. As soon as I can get some front motor mounts I can finish straightining the frame. I went to Infamous choppers during lunch today but the lights where out and no one was home. Where is a bike shop that will have harley shit in stock thats close enough to Carnegie to go on lunch? That good news. Only need to cut some spacers and you’re good to go. Like Jeff said, go to Roll-On. Only about 10 minutes from you, down Noblestown road. I used to go there once or twice a week. Buck, the owner, has been building bikes for probably 30 years. His wife runs the cash register and knows most of the inventory. There was another guy there, Justin, that was into Buells too. They have good prices on pretty much everything. When you pick out a rear fender, make sure it’s a hardtail fender (smaller diameter). If you try to line up a softtail fender, it will look stoopid. Ask me how I know. --- _[View the full topic](https://forums.speedlife.net/t/its-chopper-time/189095)._