# KrazyKid's race car hauler.

**URL:** <https://forums.speedlife.net/t/krazykids-race-car-hauler/253336>\
**Category:** Builds\
**Created:** [July 19, 2010, 7:16am UTC](https://forums.speedlife.net/t/krazykids-race-car-hauler/253336 "2010-07-19T07:16:16Z")\
**Posts on this page:** 1\
**Showing post:** 34

<div class="post-metadata">

**Author:** ![KrazyKid](https://yyz2.discourse-cdn.com/flex034/user_avatar/forums.speedlife.net/krazykid/32/6371_2.png) [@KrazyKid](https://forums.speedlife.net/u/KrazyKid)\
**Post date:** [September 30, 2010, 7:30am UTC](https://forums.speedlife.net/t/krazykids-race-car-hauler/253336/34 "2010-09-30T07:30:24Z")

</div>

> [@Wayne64SS"](#):
>
> nice work bro!!! now all you need is a truck to tow it!

thanks man! yeah I need a new truck!!!

> [@97 Camaro Anniv. Edition Dispute](https://forums.speedlife.net/t/97-camaro-anniv-edition-dispute/35394/4):
>
> One problem with that is you don’t know where the load is centered on the truck, and if you’re putting a winch on it you NEED to check out my trailer. I put a pretty sick winch setup on it. Wayne can verify.

What do you mean load centered on the truck?

I thought about the winch setup and need to check out yours for sure. My idea was once I make the tire rack and work bench/tool storage shit on the front i would make a big plate and build it on the floor up there. then put a steel roller on the break over point ont he back of the trailer to allow the cable to slide over the break over point until the front of the car was high enough to get the cable off the bed. what do u think?

> [@Vids: In Car Lap at Dunville in Project Voltron and MORE](https://forums.speedlife.net/t/vids-in-car-lap-at-dunville-in-project-voltron-and-more/35393/9):
>
> Did you find a place to put the ramps at on the trailer while not in use?
> 
> Yea cars sitting a bit forward a few feet if it was towed like that.

Neg not yet. I have some angle iron I was going to make slides for them to slide in under the trailer from the side of the trailer and hold in with the reciever pins I used to mount them to the tabs on the back bumper. But for now, huck them into the truck bed and call it a day.

---

_[View the full topic](https://forums.speedlife.net/t/krazykids-race-car-hauler/253336)._
