# Mike's Sol

**URL:** <https://forums.speedlife.net/t/mikes-sol/235240>\
**Category:** Builds\
**Created:** [December 13, 2007, 3:55pm UTC](https://forums.speedlife.net/t/mikes-sol/235240 "2007-12-13T15:55:54Z")\
**Posts on this page:** 1\
**Showing post:** 706

<div class="post-metadata">

**Author:** ![Boxersix](https://yyz2.discourse-cdn.com/flex034/user_avatar/forums.speedlife.net/boxersix/32/6327_2.png) [@Boxersix](https://forums.speedlife.net/u/Boxersix)\
**Post date:** [October 13, 2010, 6:23pm UTC](https://forums.speedlife.net/t/mikes-sol/235240/706 "2010-10-13T18:23:59Z")

</div>

> [@FS:audio system 4 sale](https://forums.speedlife.net/t/fs-audio-system-4-sale/35839/2):
>
> Its a broken steel bolt jammed into the aluminum casing, I’m reluctant to have at it with a die grinder and even less with a drill bit. As you said, the dowel is going to locate the trans and any slop will prevent it from doing its job.
> 
> I’d rather wait and have it done professionally then to botch it. My concern right now is just a simple mockup so I can weld the frames back up.

ohhh, ok then yeah better that :lol

got message too. I will be working up some rough jigs next week at some point. I will need a little $$ towards that material at some point but not a huge issue right now.

bearings/hubs…as soon as you can get them to me I can use them. I plan to locate off the inner bearing races as a fixed point for the jigs…bearings more important than hubs but both would be nice

front bar…I’ll get that quote to you tomorrow at some point.

---

_[View the full topic](https://forums.speedlife.net/t/mikes-sol/235240)._