# Mike's Sol **URL:** https://forums.speedlife.net/t/mikes-sol/235240 **Category:** Builds **Created:** [December 13, 2007, 3:55pm UTC](https://forums.speedlife.net/t/mikes-sol/235240 "2007-12-13T15:55:54Z") **Posts on this page:** 1 **Showing post:** 927
### Author: ![Mafdark](https://yyz2.discourse-cdn.com/flex034/user_avatar/forums.speedlife.net/mafdark/32/6322_2.png) [@Mafdark](https://forums.speedlife.net/u/Mafdark) #### Post date: [February 1, 2011, 1:50pm UTC](https://forums.speedlife.net/t/mikes-sol/235240/927 "2011-02-01T13:50:49Z")
> [@OFFICIAL '07-'08 BUFFALO SABRES SEASON THREAD](https://forums.speedlife.net/t/official-07-08-buffalo-sabres-season-thread/36504/460): > > Shit, I guess my rough offset calcs were alot closer than i thought! That sucks because the plates had plenty of material(prior to machining) to have left another .125" thickness on there overall. Looks like you might need a small wheel spacer/shim regardless. > > Damn > > Those lower arms don’t look half bad for temp reps either. That guy bend them up out of square stock? offset was correct, the 10" wide 18mm offsets didn’t fit, i’m not sure if they fit before or not. The 9.5" 20mm offsets fit. We will do a small spacer just so I can run the 275"s on the 10" out back. The lower arms actually look good, but they’re junk, square stock was too small, offset too much. I haven’t had time to measure them yet, but I’m not sure what was wrong with the offset, whether he did it to my specs or if my specs were wrong. anyway, trip down to GA was tough on her. even though I coated as much as possible with etching primer it all rusted anyway. Hopefully I can get it all cleaned up and actually powder coat it all within the next couple of weeks. --- _[View the full topic](https://forums.speedlife.net/t/mikes-sol/235240)._