# Mike's Sol

**URL:** <https://forums.speedlife.net/t/mikes-sol/235240>\
**Category:** Builds\
**Created:** [December 13, 2007, 3:55pm UTC](https://forums.speedlife.net/t/mikes-sol/235240 "2007-12-13T15:55:54Z")\
**Posts on this page:** 1\
**Showing post:** 928

<div class="post-metadata">

**Author:** ![Boxersix](https://yyz2.discourse-cdn.com/flex034/user_avatar/forums.speedlife.net/boxersix/32/6327_2.png) [@Boxersix](https://forums.speedlife.net/u/Boxersix)\
**Post date:** [February 1, 2011, 2:40pm UTC](https://forums.speedlife.net/t/mikes-sol/235240/928 "2011-02-01T14:40:28Z")

</div>

> [@this game is hot](https://forums.speedlife.net/t/this-game-is-hot/39329/8):
>
> offset was correct, the 10" wide 18mm offsets didn’t fit, i’m not sure if they fit before or not. The 9.5" 20mm offsets fit. We will do a small spacer just so I can run the 275"s on the 10" out back.
> 
> The lower arms actually look good, but they’re junk, square stock was too small, offset too much. I haven’t had time to measure them yet, but I’m not sure what was wrong with the offset, whether he did it to my specs or if my specs were wrong.
> 
> anyway, trip down to GA was tough on her. even though I coated as much as possible with etching primer it all rusted anyway. Hopefully I can get it all cleaned up and actually powder coat it all within the next couple of weeks.

Yeah etching primer is still porus. You’d have to use that then a primer sealer to get them locked in.

stuff can always be soda blasted. little surface rust that this stage isn’t going to hurt it much. pick up some PPG 579 metal cleaner and use that 100% strength and it’ll prohibit the major stuff from forming.

---

_[View the full topic](https://forums.speedlife.net/t/mikes-sol/235240)._