# pjb,s e/bay build up **URL:** \ **Category:** Builds\ **Created:** [December 28, 2008, 2:38pm UTC](https://forums.speedlife.net/t/pjb-s-e-bay-build-up/241027 "2008-12-28T14:38:15Z")\ **Posts on this page:** 1\ **Showing post:** 197
**Author:** ![PJB](https://yyz2.discourse-cdn.com/flex034/user_avatar/forums.speedlife.net/pjb/32/6389_2.png) [@PJB](https://forums.speedlife.net/u/PJB)\ **Post date:** [August 30, 2009, 8:04pm UTC](https://forums.speedlife.net/t/pjb-s-e-bay-build-up/241027/197 "2009-08-30T20:04:32Z")
> [@FS: PHY107 Textbook w/ WileyPlus internets code](https://forums.speedlife.net/t/fs-phy107-textbook-w-wileyplus-internets-code/22295/3): > > Hes there right now… Stalker. :tongue > [@Alternative to Adelphia (timewarner)](https://forums.speedlife.net/t/alternative-to-adelphia-timewarner/22294/7): > > is the damn motor in this bitch yet?!?! No, unfortunately not. We had a few minor set backs and things that needed attention. Its on the engine hoist now and just about set to go in. When we checked out the steering rack I bought it pissed fluid that was blacker than used motor oil so Ive gotta either get a rebuilt one or get that one rebuilt. Something screwy with that one because even after flushing it a few times the fluid was black. Then the pilot bearing didnt fit into the crank and needed to be ground down a bit to fit. It was too wide for some odd reason. Then the pins on the flywheel that hold down the pressure plate didnt quite fit. They were from my old flywheel. Still going to be ready for the LG show. --- _[View the full topic](https://forums.speedlife.net/t/pjb-s-e-bay-build-up/241027)._