# Sleeved and Built GSR Bottom End **URL:** \ **Category:** Classifieds\ **Created:** [November 15, 2008, 8:43am UTC](https://forums.speedlife.net/t/sleeved-and-built-gsr-bottom-end/200687 "2008-11-15T08:43:56Z")\ **Posts on this page:** 4\ **Page:** 1
**Author:** ![turbob16](https://avatars.discourse-cdn.com/v4/letter/t/da6949/32.png) [@turbob16](https://forums.speedlife.net/u/turbob16)\ **Post date:** [November 15, 2008, 8:43am UTC](https://forums.speedlife.net/t/sleeved-and-built-gsr-bottom-end/200687/1 "2008-11-15T08:43:56Z")
I have a b18c1 gsr block from benson, its bored out to a 2.0 liter and sleeved, it has 9:1 cp pistons,pauter rods,arp rod bolts, type r oil pump,acl race bearings, ls micropolished crank, oil squirter block off, there is a ton of money into this block and its good to well over 600whp, i need to sell it to fund my new car - the price is 1500 ![http://i534.photobucket.com/albums/ee347/turbob162008/photo65.jpg](http://i534.photobucket.com/albums/ee347/turbob162008/photo65.jpg) ![http://i534.photobucket.com/albums/ee347/turbob162008/photo88.jpg](http://i534.photobucket.com/albums/ee347/turbob162008/photo88.jpg) ---
**Author:** ![bald1one](https://avatars.discourse-cdn.com/v4/letter/b/9de053/32.png) [@bald1one](https://forums.speedlife.net/u/bald1one)\ **Post date:** [November 15, 2008, 11:08am UTC](https://forums.speedlife.net/t/sleeved-and-built-gsr-bottom-end/200687/2 "2008-11-15T11:08:58Z")
whats the bore size? ---
**Author:** ![turbob16](https://avatars.discourse-cdn.com/v4/letter/t/da6949/32.png) [@turbob16](https://forums.speedlife.net/u/turbob16)\ **Post date:** [November 15, 2008, 12:27pm UTC](https://forums.speedlife.net/t/sleeved-and-built-gsr-bottom-end/200687/3 "2008-11-15T12:27:35Z")
84mm ---
**Author:** ![turbob16](https://avatars.discourse-cdn.com/v4/letter/t/da6949/32.png) [@turbob16](https://forums.speedlife.net/u/turbob16)\ **Post date:** [November 16, 2008, 9:06pm UTC](https://forums.speedlife.net/t/sleeved-and-built-gsr-bottom-end/200687/4 "2008-11-16T21:06:55Z")
SOLD