# Stillen SMIC's Installed!

**URL:** <https://forums.speedlife.net/t/stillen-smics-installed/137611>\
**Category:** Canada Nissan Automotive\
**Created:** [May 29, 2004, 8:23am UTC](https://forums.speedlife.net/t/stillen-smics-installed/137611 "2004-05-29T08:23:40Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![Dconz](https://avatars.discourse-cdn.com/v4/letter/d/838e76/32.png) [@Dconz](https://forums.speedlife.net/u/Dconz)\
**Post date:** [May 29, 2004, 8:23am UTC](https://forums.speedlife.net/t/stillen-smics-installed/137611/1 "2004-05-29T08:23:40Z")

</div>

Well about 7-8hours to do start to finish. Then it rained like a bastard so I haven’t even taken a test run yet. I have some pics but there are install notes that are already done up on [Twinturb.net](http://Twinturb.net) for anyone thinking about doing the job themselves. It wasn’t that hard other than the extremely tight fitment in the stock locations. Signal harnes wiring mod required and a new harness was included in the kit. It just changes the bulb socket to a 90 degree instead. It still hits the cooler and I think to get the right air flow and fitment I am going the have to change my fascia eventually. I did not reuse my factory air guides, there were mixed comments about this but it would have been even a tighter fit with those in. So they are in my “removed” pile!

---

<div class="post-metadata">

**Author:** ![Dconz](https://avatars.discourse-cdn.com/v4/letter/d/838e76/32.png) [@Dconz](https://forums.speedlife.net/u/Dconz)\
**Post date:** [May 29, 2004, 8:23am UTC](https://forums.speedlife.net/t/stillen-smics-installed/137611/2 "2004-05-29T08:23:40Z")

</div>

Well about 7-8hours to do start to finish. Then it rained like a bastard so I haven’t even taken a test run yet. I have some pics but there are install notes that are already done up on [Twinturb.net](http://Twinturb.net) for anyone thinking about doing the job themselves. It wasn’t that hard other than the extremely tight fitment in the stock locations. Signal harnes wiring mod required and a new harness was included in the kit. It just changes the bulb socket to a 90 degree instead. It still hits the cooler and I think to get the right air flow and fitment I am going the have to change my fascia eventually. I did not reuse my factory air guides, there were mixed comments about this but it would have been even a tighter fit with those in. So they are in my “removed” pile!