# Z06 BUILD DONE!!??.... **URL:** \ **Category:** Shift518 Automotive\ **Created:** [June 19, 2013, 4:05am UTC](https://forums.speedlife.net/t/z06-build-done/267247 "2013-06-19T04:05:23Z")\ **Posts on this page:** 1\ **Showing post:** 227
**Author:** ![TurboTravis](https://yyz2.discourse-cdn.com/flex034/user_avatar/forums.speedlife.net/turbotravis/32/6406_2.png) [@TurboTravis](https://forums.speedlife.net/u/TurboTravis)\ **Post date:** [August 17, 2013, 10:36am UTC](https://forums.speedlife.net/t/z06-build-done/267247/227 "2013-08-17T10:36:40Z")
> [@The Gas Mask Project Series Photos](https://forums.speedlife.net/t/the-gas-mask-project-series-photos/53263/59): > > The corn is pump fuel , I’m gonna stand by that cause its what I’m gonna run also lol . Still room for better fuel than e anyway . Travis’s car is deff fast ill never say it isn’t , I applaud Trav for doing what he did with his parents as many wont do it . Emans car was built not bought , Travis car was bought and semi refined not built . Emans car is nowhere near maxed out , his only limit is belt slippage over 8 psi but like I said I can get another 100+ h.p out of it as it sits . Thanks for the positive statement about my parents. Even if it was just selling us a hood, you helped us reach an important goal. In regards to the ‘semi refinement’, here it is (what I remember) 1)Bottom end rebuild with new rods/pistons 2)Replaced cylinder head/valvesprings/etc 3)Uprgraded head studs 4)Upgraded fuel rail/injectors/fuel line/fuel pumps/2nd fuel pump triggering system 5)Replaced pressure plate/all clutch hardware 6)Upgraded clutch slave hyralic hose 7)Removed/replace entire rear diff 8)Upgraded ignition (twice) 9)Upgraded header, exhaust housing, lower intercooler piping 10)Powercoated basically everything 11)Upraded radiator 12)Installed (2) oil coolers 13)Installed FJO wideband on custom bracket 14)Installed oil pressure, oil temp, water temp and ethanol content gauges 15)Installed STM small brake kit 16)Sourced/installed 2 piece aluminum driveshaft 17)Rebuilt/repaired throttle body 18)Repaired entire wiring harness 19)Installed alternate map switch 20)Performed signifigant weight loss on the entire car 21)Engineered/R+D’ed fuel additive to combat E85 injector gunking 22)Installed 3 port boost solenoid Thats about it for things off of the top of my head… I maintain/upgrade aircraft mechanical/electrical systems for a living. I take my job very seriously as there are lives on the line each time a pilot leaves the ground in an aircraft that I’ve maintained. _ **You cant pull over at 10000 feet if the engine stalls or if you can’t control the aircraft.** _ I put the same level of integrity into working on my cars. The Evo was ‘unsafe at any speed’ when I purchased it and I’ve worked very hard to take it to where it’s at today. --- _[View the full topic](https://forums.speedlife.net/t/z06-build-done/267247)._