2007 suzuki Rm 265
race ready. big bore, porting , and head mods done by eleven10 mods, has an Exteme coated piston from Max Power RPM’S and a Hot Rod crank
suspension has pro circuit valving and internals . front forks have the pro circuit anodized inner spring tubes in them, and the rear shock has the pro circuit works kit and pr2 works bump stop on it
pro circiut linkage arm, magura hydraulic clutch, oversized front brake setup, pro circuit platinum pipe and r-304 shorty silencer, Moto Tassinari Delta VForce 3 reed cage. also have a few extras (spare piston kit, stock pipe and silencer, stock read cage, stock clutch lever and cable, extra plastic and possibly a graphics set)
looking for $3600obo possible trade on a 450
located in the greensburg/latrobe area
pm me on here for contact info
2001 suzuki Rm265
need put back together. i pulled the engine apart to repair and never finished. i have new main bearings for it, it will need the bridges in the cylinder welded and replated. roughly $150-225 to do it depending on where you send it. and a new swingarm bolt and bearings. i’m pretty sure that’s all it needed.
the picture below was taken in september of 06 about 2 weeks before Ii pulled the motor. it’s been sitting in boxes in my basement ever since. it has a big bore cylinder and port and head mods by eric gorr , fmf fatty pipe and silencer , oberg upper tripple clamp, Moto Tassinari Delta VForce 3 reed cage, the suspenion has stiffer springs.
looking to get $1100 as is or trade on a clean 125
located in the greensburg/latrobe area
pm me on here for contact info
