FS: 60# Mototron Injectors

Classifieds
1

I’ve used these for the last couple years. Still work perfectly.

Racetronix Part # L107FM Part # 107961 (Siemens FI114961 - Mototron INJ-GAS-006 - Accel 74620L - MSD/Edge 2030)
All tests run with n-Heptane (0.6855g/mL) @ 20oC (+/-1oC), 3.0 Bar (+/-0.01 Bar) (43.5PSI) , 14VDC (+/-0.05VDC), saturated driver. Engineering data specifies a flow ratio of apx. 1.035:1 when converting to gas. Static Flow Rate: 60.56 lb/hr = 668 cc/min = 458 g/min (+/-6%)
Dynamic Flow Rate 2.5ms PW @ 100Hz @ 600KPa: 19.5 mg/pulse (+/-6%)
Coil Resistance: 12 Ohms (This high-impedance injector will work with all factory ECM/PCM injector drivers)
Gain: 0.11ms/mg
Offset: 0.055ms
Turn on time @ 14VDC: 1.14ms
Turn off time: 0.85ms @ 600KPa
Spray Pattern: Cone (4-Hole)
Connector: Minitimer (Bosch EV1)
> Click here for dimensions <
Factory fitted with Viton upper and lower o-rings.
Grease supplied to lubricate o-rings prior to installation.
Dynamically flowed and grouped to within 1% tolerance using Racetronix custom injector flow bench

http://www.racetronix.com/product/Injectors/L107-1.jpg
L107-1.jpg800×855

$250

2

what do these fit

3

i know they fit all LS1 cars and trucks, i believe late model fords, including fox style mustangs, but beyond that, i really dont know.

They have an Bosch EV1 aka Minitimer connector

if they are the proper size, but not the proper connector, you can buy adapters or new plugs

4

comon, somebody wants to go fast, i know it!

5

last bump before they go on ls1tech