Many Parts left over from swap – ['96 SR20DET 5-speed Clip into '95 KA24DE Auto s14 240sx]
All Parts available for pick up in Waterloo Some parts can be transported to the GTA (at my convenience).
PM or email: benjamin@vrspeed.com for more information
—Engine / Engine Bay—
-s14 stock muffler $40- (Almost no rust)
-KA Radiator w/electrical AC fan & Mech Fan $30- (Stock '95 s14 setup) Shroud Cracked – Price Drop
-Aluminum intake pipe for KA $40- (Connects MAF to intake, with all vac. lines, blue silicone couplers):
-KA Air Cond System $100-
All parts (compressor, rad, tank - minus main cold and main hot line) Blew cold and quiet before removal.
-Various 95KA/96SR Fluid Reservoirs- ($All B.O$):
-SR/KA Power Steering Reservoir
-KA Washer Reservoir
-SR Coolant Reservoir
— Electrical —
-1996 JDM s14 Digital Climate Control $300- All sensors, all wiring, complete & out of clip:
-1995 s14 Auto ECU $50-
Swap into 5-speed car for instant speed cut removal.
-SR/KA combination switch (light & wiper stalks) $30-
-Big-ass Tach. Lights up 6 different colours! $15-
Various 95KA/96SR Electrical Controllers- ($All B.O$):
-KA Cruise control Processor
-SR Smart Entrance (locks, security) Controller
-KA Auto Transmission Controller
-KA/SR Washer Motor Amplifier
—Body/Trim/Plastics—
-Stock '95 s14 Fog lights $150-
Work perfectly but don’t fit with my FMIC piping
-Stock s14 rear Bumper Facia & Foam $50-
Factory FN2 (Green) colour, few paint scratches:
-Wiper/Vent Plastic Finisher Plate $15-
(black, sits under wipers, against windshield)
Various Interior Plastics from Clip $Free/B.O.$
[Send me a picture of what you are looking for, no tranny swap parts]
—Brakes/Hubs/Suspension—
-JDM s14 Brake Booster & 15/16 Master Cylinder Assembly $90-
Good Upgrade! JDM s14 uses this to drive z32 4-pot brakes:
-5-Bolt JDM Hubs & Front Upright Assembly $80-
90k km, no rust, has z32 big-brake rock shields!
(springs, shocks, LCA not included)
-s14 Drop Zone Lowering Springs (Set of 4) $80-
Used, No Winters, fit on stock shocks. Unknown spring Rates, No bounce or camber problems (stiffer than stock), greatly improve appearance & reduce body roll:
-Stock T/C Rod Pair $30- (Stock, bad bushings)
-KA clutch pedal (for 5-speed swaps) $40-
-s14 front brake callipers & Lines, Stock work well $40-
-s14 rear brake discs, used. $10-
—Misc Free/B.O. Bin—
2 sets of Pimptastic Blue/White Light-up Indiglo s14 gauge stickers.
Unique appearance. All wiring but no instructions:
s14 KA Intake system parts - various, stock.
s14 Drive Shaft engine half only (fits all)
SR RHD Brake Pedal (Bracket same but pedal RHD only!)
SR Power steering lines.
SR Gas Pedal (Positioning slightly different)
Clutch damper circuit (I recommend removing this)
Misc Wiring harness parts from SR
(All the SR clip dash and engine compartment wiring in a box)
Various intercooler T-style piping clamps
If you are looking for the steel supporting bracket you can’t see, yes I think I have that.
justin il give ya a shout… thanks…