B-Series Turbo Parts and More

No takers on my built lower end. So heres a part out list.

JDM B18b block, 81.5mm over w/ micro polished LS crank, GSR oil pump, plained deck $300
Scat H-beam rods w/ACL Full Race bearings $200
CP 9:1 81.5mm GSR Pistons $200
3 Rib crank pulley $40
Thermostat housing and water pipe $30
Drivers side engine mount and bracket $40
Black 90* -10AN fittings $30 for 2
Baffled vented catch can w/ drain $75
Greddy turbo timer $40
Blitz turbo timer $40
Resistor box $20
OBD-0 injector clips $10
3" top mount down pipe, 3" v band, flex pipe, 3 O2 bungs $80
3" Catback, steel, all V-band, Blox race silancer, built for integra $250
IC piping, steel, built for top mount integra, 50MM BOV, all couplers/clamps, IC included $175
OBX top mount manifold, 44mm v-band WG flange, repaired a couple times $75
Dual 2" gauge OEM Integra center vent $60
Brand New test Pipe w/ hardware $40
Wings West skirts and rear lip 94-97 integra $100

Few pics, can get more if needed.
http://i167.photobucket.com/albums/u147/reckone518/3K33G53I55I25G35K9d576f6f0c72e79b1cb8_zps5ff0e041.jpg

http://i167.photobucket.com/albums/u147/reckone518/20130416_113954_zpsdc7821e3.jpg

http://i167.photobucket.com/albums/u147/reckone518/20130317_140737_zpsd4f20051.jpg

http://i167.photobucket.com/albums/u147/reckone518/20130417_132508_zps94e37241.jpg

http://i167.photobucket.com/albums/u147/reckone518/563544_10151627262861463_292981000_n_zps71d35287.jpg

http://i167.photobucket.com/albums/u147/reckone518/wings_zps9579c0ee.jpg

ill take the motor mount and bracket

I’m free before 2pm most days. Just let me know when you want to meet up. I’m in schenectady by mohawk commons.

would you sell just the intercooler?

Id rather keep it with the piping etc

Rec. u dont have your old broken tranny.

Iv never broken a tranny.

Up

Bump

Hey how much for the manifold and down pipe?

$150 on both.

the exhaust that your selling does that bolt up to or vband to the down pipe ??? ill pm you my number text me anytime