FS: 1987 rx7 shell some other goodies

it needs a boost pressure sensor, fuel injector resistor and an air flow meter. it needs these parts from a turbo rx7 because my car was non turbo and i swaped a turbo motor into it. the compression is good. it is just getting to much gas(the sensors that are needed for the swap) and it will rip. i just dont have the time to fine tune it and get it running cuz im moving soon. it cranks over but then it just back fires from not getting the correct air fuel mixture.

well i found a winter car so just looking to sell it before May cuz im moving to AZ.

BUMP

be you em pee

bump

want to give up the non turbo afm since it is not needed also might want the non turbo 460cc injectors from your old engine

oh sure doug im closer i need on too, what code is the turbo one i might have a board for one? b is non i know that, but you can have it if i know the code…

interior and na-motor

bump

.

these were the plans.
http://images.google.com/imgres?imgurl=http://www.mazdausa.com/MusaWeb/images/mazdaspeed/personal32/img_mazdaspd_tuning_personal32_content00.jpg&imgrefurl=http://www.mazdausa.com/MusaWeb/displayPage.action%3FpageParameter%3DmazdaSpeedTuningPersonal%26sectionParameter%3DtunerProfile32&h=76&w=164&sz=5&hl=en&start=16&um=1&tbnid=4SSNa4lN8DQUNM:&tbnh=45&tbnw=98&prev=/images%3Fq%3Drx7%2Bheadlight%2B%2Bconversion%26um%3D1%26hl%3Den%26safe%3Doff%26client%3Dfirefox-a%26rls%3Dcom.ubuntu:en-US:official%26sa%3DG

bump

Have you tried selling this on RX7club? I’m sure you’d have better luck over there than on here so far.

YA THANKS

sell just the shell minus motor tranny and ecu?

are you asking me or telling me?

asking

if it was running i would trade gl!!!

Trade what your civic?

yah