2.5" ractive muffler with the 4.5" tip cut off…$25 (will include the tip if you want it)
d16z6 bare block with girdle, and head bolts $15
d16z6 rods and pistons $5 each set
wastegate actuator (around 7-8 psi) $20
stock d15 injectors (240cc) $10
b18a head with valve cover $50
Injector clips $15 each set
Resistor box $20
10w10ohm resistors SOLD
hf/vx/std manifold for your d-series turbo setup $50 pending
92-95 civic power steering rack. i was going to try to convert it to manual, or you can buy the stealthmodeperformance.com conversion for $92 shipped…$25
2 bolt drivers side D series upper mount…$10
Shift boot, ebrake boot black with red stitch, bought from redlinegoods.com genuine italian leather $40 (custom fit for a 92-95 civic)
GSR rear tranny bracket (needed to install a B series in a 92-95 civic) $45
High Temp silicone vacuum line 2 sizes $5
Anyone need any honda sensors / sockets / plugs ?
B18 intake manifold $40
b series obd 0 alternator $45
b18 oil pump $40
haha, thanks minglor. yeah, its just a bare block with a crank girdle, and head bolts. no crank included. no rust on the cylinder walls, this was a short block i bought, it had a spun rod bearing, nothing else was harmed.
the only scratch is the scuff in the top center of the screen, seen in the pictures. $20 is too low. i can do $40
thanks guys. ive had lots of interest, the only thing actually gone is teh rear strut bar.
yeah thats fine. ive got someone interested in just the girdle, so come and pick it up this weekend, and its yours. $20 is perfect. you can look through all the pistons. take which ever ones you want.
payment was sent for the hf manifold on another forum…SALE PENDING!
im in orchard park. give me a call. its the best way to get a hold of me, my computer is acting up. 716-861-9556. i probably have the o2 plug on the engine harness side. dont have an o2 sensor and sale is pending on the o2 bung.
is adictd2boost still interested in the d16 block?
i still have the 91 civic hatch for sale. ill sell it with the partial b18 swap for $1600 as a combo only. it would make a great winter project. stock b18’s are good for 300 whp, and if you throw a forged bottom end, you can push over 600 whp on the stock sleeves.
