so he’s starting tomorrow? I promise there wont be any harm.
:gay2 :wtf
oh dear
stop putting words in my mouth
Great, yet another thread ruined.
looks good dude. where are you putting this again?
In the rear bumper for the cutoff switch. Off to the right. I gotta pick up some black rivets and drill some holes to mount it.
so adam ,i thought about this to get the bend ya need .next time ya hittin some c/p hold it in your hand and slap her ass in the middle of it get her off and get the bend ya need
ahh, you shopped it in the sig pic. looks nice.
Wat…:rofl
:rofl No, he had one there…this is to just make it look nicer.
Oh no, thats the old one that is WAYYY huge. I used that just to pass tech at LVD one night, This setup is gonna look alot better.
mmmmmmmm
i like how bob at inline’s cutoff on his stang is setup, its drilled through the trunk and comes out at the NYS symbol in the middle of the license plate
oh man, why didnt you guys tell me? i asked about this like twice. 
It’s not gonna bend unless it’s heat cycled in the position you want it in. You should have modled it to the location you wanted it, then taken it off and trimmed it after it cured. :number1
It was a pre-made sheet, thats the problem. Its straight right now and I need just a SLIGHT curve on it…
:excited C/P! johns funny.:lmao
i like how bob at inline’s cutoff on his stang is setup, its drilled through the trunk and comes out at the NYS symbol in the middle of the license plate
01 TT ZO6
96 Mystic Cobra 91MM
BIG Motorsports-building the areas fastest street cars since 02.