hey guyz heres the problem, i picked up a set of rims from a guy , he had some roh deep dish on his car, he had an acident in the front and the front rims are toast,so he told me the bolt pattern were the same as my 240, i have a 92, his car was an old rx7, so i got the rims and they dont fit , they are 4 bolt but they are off by a little bit, io think they are 4x100 bolt pattern, now these rims are 8" wide and are deep, they are good if u want to drag race, ? how do i get them to fit, should i drill them over to fit or drill the holes bigger, or sell them off to some honda guy!! lolz
if u want to see what they look like take a look at blu240 post with testing waters with ROH 17 …( something like that)
neways ilike these rims, tell me how i would get them to fit!!!
thanks
FB is 4x110 the only cars of any volume that would be interested are older 80’s, 4 bolt mustangs and other SA/FB owners.
good luck it’s not a common PCD now .
4bolt mustangs are 108mm
Just about all civics are 4x100
all FB’s are 4x110 except the 85 SE which is 4x114.3 I know thier is an ( ~ 85’ ? ) mustang with a 4x110 bolt pattern because the FB guys use them ALL the time… 4x108 is modern Focus PCD but I have no idea when the mustang went to 108 PCD
thanks guys, my friend told me the same, older 4 bolt mustang guys used these rims alot, the rx7 it came of was an old one, it had pop up lights, donno wat year it is but hey, i want to use these rims, i might drill new holes or something donno yet, open for advice…
you would have to redrill new holes. they are nice looking rims 8)
they ALL had/have pop up lights…
but since they don’t fit your 4 bolt then they are the SA/FB 4x110’s.
hey thanks guys for ur input, blu240>> yes indeed ther are nice rims, u have them so u know wat i mean, am for BAS and everyone else thanks for the advice, am, i might just go ahead and re drill new holes, newayz thanks guyz
sean
what the hellz a rimz?? 240z arent the zame az rx-7z, 4/5 x 114.3 and 5 x 100
WTH is that ^^ actually trying to say… get off the crack.
I think he is trying make it sound like he is speaking in his sleepZzzzzz
Tinitunerzzzz you should get the wholes redrilled to the right specification for your car. Have if done professionally at a rim shop so the measurements are dead on otherwise if you screw it up by doing it your self you will be opening up a new can of worms, so spend a little extra and get it done properlyzzzzzz.
FC center bore is FAR smaller than teh s chassis’s fb adn fc wheels will not fit at all
use spacers to fix the bore problem?
huh didn’t even think of the hub center being smaller. however you can get termocomposite hubcentric spacers to fill that gap properly for like $20.