I have a couple of good motors around and need to sell.
All combos should be high to mid 11 sec and 10 sec combos or better depending on head choice if any and vehical setup.
But all of them have run 10.6-11.9 or better.
350 + .040 = 356 cubes, late 87 block 1 pc rear seal, roller block.
stock crank, stock rods,TRW Hyper pistons 8cc 4 valve relief, balanced.
Less than 1000 miles on since complete rebuild.
This engine with 248/252 solid flat tappet and dart heads on pump gas run 11.9s in my 3400 lb camaro w/3200 stall.
Also have:
350 + .030 = 355 cubes 4bolt
Chevy steel crank, Eagle 5.7 rods, TRW 16cc dish forged pistons,
This engine was used with my p600 blower and carb setup,
Best et 10.6 @ 128 on pump gas…
Currently in need of 1 piston, but will fix along with new rings and bearings if interested.
It knocked the ring land off # 6 - no damage to cylinder…
Also have:
My current 400 + .030 = 406 cubes,
Scat cast crank, Cat 6" rods,SRP forged 16cc dish pistons…
Currently down for new bearings and rings - but in great condition… Not “really” looking to sell but will if price is right.
This with my 195 afrs run 10.89 natural in my 3450 T/A on pump gas with conservative gears and TCI super street locking converter.
All (3) engines have been bored with a Torque plate bore, and have been squared.
Heads:2.05/1.60 Alum.
AFR comp ported 195cc runners w/58 cc chambers, current springs 190 seat/480 @ 575 lift. will occomodate 650 lift.
Also have Hyd roller springs available. 150/320
Dart pocket ported. Iron.
2.05/1.60 200cc runners
Cant remember spring rate off hand but will get.
Both in great condition…
Also some cams,
242/242 solid roller 575/575 @ 112,
248/252 Flat tappet solid @ 108 lsa…
Pick up or local to PA delivery available…
EMAIL with Q’s
TKADAR@COMCAST.NET