hey
so i wanna install some kind of illumination in my silvia logo. standard silvia badge (between the two lights) but i wanna like light up the letters, looks boring.
any tips on opening the badge without cracking the casing or lens? thanks
I did a set of corner lenses for a silvia.
- -in the oven at 150 for 10-13 minutes, just enough to soften the butyl(?)
- -then I used a tiny flathead screw driver to pry open the tabs, and pull the front apart from the rear section.
- -then I switched the broken rear/front sections.
- -back in the oven for 10 minutes to “reseal” the butyl.
but you could probably putting holes into the rear panel for LED’s and not have to take it apart
nice ill give it a shot…