Full custom one off turbo I built initially for my s2000. Everything is brand new inside it.
These are originally big shaft turbo’s otherwise known as a T58. The compressor side is a .55a/r housing and and a 50 trim wheel (2.3ind/3.3exd aka 58mm inducer). It flows 55lb/min.
The center section is brand new turbonectics which was fully custom machined and sized for the big shaft option, yet accepts normal garrett oil inlet and outlets.
The turbine side is a brand new precision .63a/r 5 bolt housing sized for a stage 3 turbine wheel… I was actually planning on running it internal gate for room reasons in the s2k engine bay. Any housing can be swapped onto the CHRA if it isnt want you want.
With this combination, it should be a very fast spooling 500hp capable street setup.
I’m giving it one shot in the classifieds to sell since I havent had anything to use it on and I have a lot of money wrapped up in it. If nothing happens, then it might go on my 200sx. Thanks for looking!
next to a greddy td04
