SR downpipe with flex, Steering wheel with hub, 180 sx brakes, catback exhaust 647-686-0712 txt
i’ve got steering wheel hubs, catbacks and downpipes in stock
I have a Prof exhaust, and a Invidia replica for S13. 
And I have some sweet steering wheels!
Grab a DP from bing and off you go! We both live in hamilton, so kill 2 birds with one stone.
i got a full catback+testpipe+downpipe willing to sell it for cheap.
---------- Post added at 02:32 AM ---------- Previous post was at 02:27 AM ----------
its 3 inch made by motoria
---------- Post added at 02:32 AM ---------- Previous post was at 02:32 AM ----------
its 3 inch made by motoria
Anyone got sr downpipe with flex? (tired to repair broken mainfold studs lol!) Bing, how much’s hub at yr plc?
$85 for Circuit Sport short hub… u need one of these if you intend on using a quick release.
flex downpipes dont solve the manifold stud problem. flex downpipes often rub the frame or floor. They did for me and i often sub out non-flex dp’s for guys who bought the flex thinking it would solve the issue.
if you use the downpipe support bracket to the tranny and install the rest of the exhuast properly you shouldnt break studs.
the catback i have in stock is this one: kijiji ad
carbon wrapped muffler… super cheap because i brought it in as a one-off
Sorry to thread jack but where can you buy the support bracket ?
i have it all in stock - flex pipes always help …
you just have to make sure you have a good quality manifold and elbow, and engine mounts ( to make sure the exact location of turbo didnt change from oem )
LOL at flexpipe LOL
no need to argue about it… some guys do not have issues with rubbing with flex pipes, some do.
JonPrem… your downpipe should have the support bracket built into it before the rear flange. It connects to the transmission. But you may be missing the mount on the transmission for the bracket to mount to.
I firmly (no pun intended) Believe in Nissan engineers. They used the bracket and a few hangers and it works fine. We’ve only increased the size, mounting stays the same.
Issues:
20 yr old Studs CHANGE THEM
2 hangers holding the exhaust up vs using the 2 rear, 2 subframe and transmission bracket.
Do it the right way, dont use the wrong stuff.
and get urethane hangers… hold that shit HIGH!!!
Yes, you right, the tranny hanger should matter. I did not have it, that’s why I got it with a broken stud.
Yes, the flex downpipe comes with the bracket to attach to tranny which is clutch !
Nissan engineers do make a lot of mistakes, ask any NISSAN tech about the recalls and engine swaps they do under warranty daily ! LOL
they are only human !
tranny hanger ftw
i have the 180sx brakes fs with braided teflon lines and hawk hp plus pads and brembo blank rotors off my drift car
pm me for a price