So my block is 18mm, but the 18mm filter selection blows. Im looking for a sandwich adapter, for an oil cooler, that will accept a 3/4" thread filter so I can run something hugegantic.
Has anyone seen this before? I suppose I could make my own nipple setup, but Id rather not if its already available.
Thoughts?
Dan
probably going to have to cut two “tubes” and weld in the middle, face each on a lathe and chamfer/tig and maybe spin again in a lathe to ensure it fits through the cooler plate.
Ya. I thught of that too. However, I think Im just gona get the biggest 18mm WIX filter I can find and be done with it. Itll be way easier and I wont have to worry about welding etc.
Dan