Hey guys I’m looking sell my:
S13 240sx Convertible with S14 Silvia SR20DET Engine Swap
You can see pics at:
Contact me if you need more information/pics
Sorry for the wall of text…but lots has been done to this S13!
80 000KM on engine 230 000KM on the chassis.
The Bad:
- Speedometer does not read
Frame has some rust, nothing serious. tennis ball sized hole under driver footwell, and another in the rear. Frame rails are fine, rockers are okay some rust at the ends.
Long List of Goodies!:
SR20 DET (S14 Silvia Engine/Transmission) with S15 Differential
BC 264/264 Cams freshly installed a few weeks ago
PowerFC D-Jetro Standalone ECU($2000) - BNIB with required sensors - Not installed yet
Top feed fuel Rail, Aeromotive FPR, 1000cc Top feed injectors BNIB - not installed yet. Should be done after ECU is installed.
GReddy Profec Gen II Electronic boost controller
Greddy Analog Boost Gauge
PLX touch AFR guage /w BOSCH 4.9 wideband o2 sensor
Large Front mount intercooler no blow off valve.
K&N Intake
Electric Fan w/ adjustable controller wired to ignition, only goes on when the car is on.
Bench Coil packs
Megan Down pipe
GReddy Trust full exhaust (Nice deep sound, comes with a silencer)
ISR 255 Fuel pump
32 Way Dampening Adjustable Coilovers, back can be lowered even more then in pictures, but exhaust will rub.
B&W short shifter with knob.
Sparco steering wheel with NRG 3.0 Black Quick Release
18’ Chrome Rims
Everstart AGM Battery($350) relocated to the trunk with 2 Guage wire. done properly
Pioneer Deck
Positive power distrubition block located in the car to easily connect any power sources you may need in the future, done right with a fuse and relay connected to the ignition wire.
Maintaince wise:
Changed MAF(Wont be needed after ECU install), TPS, Coolant temperature sensor
Rack n Pinion replaced with brand new one(OE)
Front LCA changed
Engine and transmission mounts changed as well
Have other parts currently not installed that could be included for the right price:
S14 JIC Magic inner tie rods (new)
S14 Costco tension rods
Synapse Synchronic BOV (used, not installed)
300zx Front Calipers
S14 Spindles with Hubs (great condition)
and some other things… you get the idea.
Asking $11000
Call/Text 905-330-6673 If you’re interested