2006 Subaru Legacy GT Limited

Classifieds
1

As of right now this is more of a feeler/interest thread to see if I can sell it as is or should part it out and sell it stock. I just bought this car and had it shipped from Louisiana. I bought it with a spun bearing and have since fixed everything. It has yet to touch a road in New York and the under body is absolutely spotless. It had a dent in the driver door and a few scratches on the exterior so I just trailered it over to a local body shop to have it fixed(the door is being replaced not filled if the dent can’t be popped out). I expect to have it done by Tuesday so I will be able to get a lot of pics at that point if there is any serious interest. I am looking to get 14k/Best offer

Details:
Year: 2006
Make: Subaru
Model: Legacy
Trim: GT/Limited
Motor:2.5 turbo
Trans: 5 speed manual
Mileage: 78,xxx
Exterior: Silver
Interior: Black Leather
Options/Amenities: 6 disk in dash cd player, under seat sub woofer, power locks/windows/moon roof, heated leather, Xm radio

Maintenance/Modifications:
Wiseco pistons
Manley connecting rods
New oem crankshaft
Acl race main/rod bearings
New oem oil pump/water pump/timing belt/timing components/head gaskets/oil pick up/oem seal & gasket kit
Act HD clutch/flywheel
Deadbolt TD-06 18g turbo
Avo inlet
Spt intake
Perrin tmic
Gfb bov
maddad/gt spec Uel manifold/up pipe combo
2 piece catted down pipe
Borla catback
Agency Power 816cc injectors/Fuel rail setup
Aeromotive Afpr
Walbro 255 fuel pump
Cobb Accessport V2
Sti strut bar
Spt f/r sway bars
Hawk Hp pads
Re-11 Tires in very good condition.

I am sure there is more that I can not remember off of the top of my head. It currently has a tune from infamous that I tweaked a little. It previously made 274/301 on this setup with a stock bottom end. I will more than likely bring it to innovative to have mike give it a new tune before it is sold. If you have any questions let me know and I will get back to you asap. I know that pictures sell cars and they will be posted as soon as I get the car back.

2

In for pics…this is probably what I am looking for.

3

These cars are nice.

4

Who built the engine?

5

The short block was checked/prepped(hone angle, clearances, etc) at Fingerlakes Machine. I also had him check and clean the heads but no machining was necessary with them. I did final assembly at my shop. Like you I am an ASE master tech and I worked at a Subaru dealership for a while so I am pretty confident in my abilities which is probably a good thing since I get paid to do this. Anyone interested is encouraged to have someone such as Don or Innovative do a prepurchase inspection on the car.

6

Top notch seller here, the man does good work!

7

Thanks for the vouch Mike. Sorry about not getting pics but this is no longer for sale. I have been driving it and like it much more than my evo so that will probably be for sale soon.

8

Curious if this is the same Deadbolt TD06/18 you were selling here or another. Or whether theseare the heads you used for your rebuild.

Can vouch for the Legacy - great cars.