Anyone have a Tech 2 scanner that can assist?

NYSpeed Automotive
1

I just replaced the crank and cam sensors plus the exhaust cam actuator control solenoid in my 2006 Trailblazer (53,000 miles) and need to perform a crankshaft angle sensor (C.A.S.E.) relearn.

Does anyone have a Tech 2 that can assist me with this since the manual process is a pain in the balls. Willing to pay/supply beer for the quick job?

Thanks!

Manual process:

  1. Turn off all of the accessories. With the Air temperature sensor and Coolant temperature within 5 degrees (Centigrade) of each other, start the engine and let it idle in Park or Neutral for two minutes.
  2. Accelerate the vehicle to 55 mph at part throttle. Cruise at 55 mph for 8- 10 minutes until the engine reaches operating temperature.
  3. Cruise at 55 mph for another 5-6 minutes.
  4. Decelerate to 45 mph without using the brakes, and maintain 45 mph for 1 minute.
  5. Perform 4 deceleration cycles, without using the brakes, of 25 seconds each where no specific speed is necessary. Returning to 45 mph for 15 seconds in between deceleration cycles.
  6. Accelerate to 55 mph and cruise for 2 minutes.
  7. Stop the vehicle and idle for 2 minutes with the brake applied and the transmission in Drive (automatic trans.) or Neutral (manual trans.) with the clutch depressed.
2

anyone?

3

Just do the Manual Process. If done at night on the highway it should only take 1 or 2 tries.