Anyone here know how to use a f'in volt/ohm meter?

[Ilya]

@Fn Skanks

dvom’s are simple to use… take a look around on the 'net and there should be a good tutorial for you…

I shoulda thought of that. I’ll take a look and see if I can’t figure out how to use the damn thing.

Thanks.

@ninety1two40

I’m not really familiar with your coil setup and would probably need a schematic or FSM to tell you how to test your harness.

To test the coil packs you’ll want to disconnect the coil pack from the car and use the meter to measure the resistance across ground and coil output, and whatever other points the FSM says.

Do you have 3 wires going to each coil (besides the sparkplug wire)?

Yeah I have three wires. I tried doing pin 1 and 3 as per FSM (if I recall, I did this the first time I had this issue 3 weeks ago) and my arrow went from nothing (as if it was off) to the complete other side (infinity?)…

I’ll search for a tutorial and see if I can’t figure it out.