Need M14 and M16 1/2 drive bits to pull my axle this weekend. Anyone have some I could borrow till Monday? = 
at Hooters
axle in what?
Passat. CV boot split in 1/2. Rebuild kit from ECS $25.
i would think you’d only need the m14 triple square for the output shaft? i have one if it’s the same as all the other vws… however it’s at the garage which i won’t be to until thurs / friday. 
C & L Tool
Address: 218 Flaugherty Run Rd, Coraopolis, PA 15108
Phone: (724) 457-4900
if you can’t find one, they have been real reasonable for tools when i need them
To pull the axle from the hub its a big ass M16 bolt, too pull the axle from the tranny theres a few M14’s.
Thurs/Fri is fine. Will call. Do I get to see any top secret stuff? :mullet: thanks.
I can get you either of them from work
SOnny call me back! GOing out to eat then to a move at Loews. If ur gonna be home around 10 just bring them with you.
If not, Cheeks, where are you?
Ive been puttin this off FOREVER but its getting done tomorrow no doubt. Thanks guys.
etna advanced auto, call me 412.841.7448
Nobdy fuckin has 16 or 14 mm hex dammit!!! ORdering online now. weaksauce
i do
i have them sitting in my garage
too late now. just have to wait for them too come in the mail. I drove to 6 different stores in the north hills and not 1 had anything bigger than a 10
why did you just not a VW person? i have them, sailor has them, sonny has them
Are they impact?
Whitey can I borrow ur 16mm and 14mm bits? :burnout:
of course