Shady
March 9, 2009, 1:42pm
1
Seriously I looked all over the area today to look for a god damn crush washer for my turbo oil feed line. Not one damn place had one of the right size… anyone have any ideas where I can get a couple?
Or if anyone on here has some that might work.
I really dont want to order 2 dollars worth of crushwashers and then have to pay 10 shipping from a dealer…
Seriously I looked all over the area today to look for a god damn crush washer for my turbo oil feed line. Not one damn place had one of the right size… anyone have any ideas where I can get a couple?
Or if anyone on here has some that might work.
I really dont want to order 2 dollars worth of crushwashers and then have to pay 10 shipping from a dealer…
Napa, or I think Harbor Freight might sell a kit with a bunch of different sizes.
Shady
March 9, 2009, 2:11pm
5
Dude I’ve been to every place
Advanced, Auto Zone, Napa, Fasten All, Ace hardware and no place has the damn things…
an aeroquip/earls dealer right by the latham circle… go through the circle towards rt2 to watervliet, its right on your right hand side.
Shady
March 9, 2009, 2:20pm
12
And thanks travis, looks ill be making a stop there when I get out of work tommorow
Worst case, I think you could make one with a couple correct size hole punches and a sheet of material. I’d just source the right ones, though.
Shady
March 9, 2009, 4:11pm
14
yeah tru, but getting a copper washer should not be that fuckin difficult lol
If you can’t get one give me a shout. I have hundreds of various crush washers at my garage. I’m sure I could part with one
Shady
March 9, 2009, 4:39pm
16
Acctualy I need two adam, and seriously I’d rahter just get a couple from you if I could rather than go buy an assortment of ones I don’t need…
Any chance you have 1/8th adapter fittings as well for an aftermarket oil pressure gauge…
As no one at any parts store around here grasps the concept of a female->male adapter fitting
The aftermarket uses a 1/8th something or other fitting versus the 1/8th NPT stock fitting
Dude I bought a couple of the assortment packs of copper crush washers from the Advance in Cobleskill, worked perfect for my Nissan :lol
Shady
March 9, 2009, 5:53pm
18
im not spending like 8 bucks for 2 washers…
dont cut corners on it, youll end up with car b que
Call me tomorrow on my cell and let me know what size washers you need. I’m certain to have them in stock, in either copper or magnesium.
What type of fitting do you need? I have lots of 1/8npt through 1/2npt stuff here, but I need to know exactly what you’re looking for.
Call the cell tomorrow, 225-8384