I have a set of brand new Skunk2 PRO Series stage 1 cams for all dohc vtec engines. They are new in box, still sealed. Specs are:
Pro Series 1+ Camshafts
IN 0.456,252 = 11.5824mm,252
EX 0.426,249 = 10.8204mm,249
I don’t have pics of the cams only because they’re still sealed in box, But if you want to see pics of the box, I will take pics.
Here’s a sample dyno graph with these cams:
200+ HP
MSRP: 700
I will take 550obo
I will take trades also
what else do you need to run these on a stock motor?
You would probably want to raise compression with a thin oem gasket, and valvetrain to rev up to infinity 
9.5k rpms
Bare minimum, you would want to do some fuel curve and ignition timing changes.
how are these big power cams? they are a stage 1, and dont have muchmore lift if any compaired to ctr/itr cams
kevin, these are PRO SERIES… not regular s2 stage1
If you look at the specs posted, they’re comparable to the regular skunk2 stage 3 cams.
According to the dyno graph, they actually make more power then buddy club stage3
i didnt see the pro series part
np, but if you’re in the 600hp club, you should know regular stage1 won’t make more then 200 hp
no flakers