I have heard a butt load of good things about these and I understand how they work SO i picked one up. Hondata BLUE gasket for my B18C1. BUT I noticed that it only has one hole in it where the radiator lines go. I thought the OEM gaskets have 2 holes…wrong or nah?
ALSO im worried about the stud length, I think with my Skunk2 IMO and this thicker gasket the studs will be to short? Should i shave the IMO down a bit on the nut side or get longer studs?
no body?
longer studs
so i do need longer studs, where can i pick them up…there not OEM right
hrmm finding the right thread pitch studs might be an issue … i think it’s going to be m12 X 1.75?
someone correct me if i’m wrong here … find out the exact thread and pitch then call round …
sears harware … hectors … the small time harware stores usually carry more obscure thread pitches like stupid honda uses.
THERE NOT EASY TO GET OUT TOO!
vise grips … worst case snanario a little heat wrench