Knuckle/hub BROKE!

NYSpeed Automotive
1

Ill start with saying this is on a 94 Honda Civic CX. I bought 2 sets of ARP wheel studs. Not knowing at the time that the whole hub/knuckle needed to come off the car and be pressed out to install them. Which means you have to basically take apart the whole front end suspension. So there I was pressing the hub out off the knuckle assembly, it pops, I think I’m all set but when I look It pressed the snap ring through the knuckle assembly braking it. I know now that the hub needs to be pressed out of the assy. first, then the bearing can be pressed off. The helms was no help here. My question is where can I get a new / used knuckle assembly? Should I look into after market/ performance or maybe a GSR front swap?

http://i197.photobucket.com/albums/aa271/shrekb18/08254_91_18_10_122_357lo.jpg?t=1186508917
http://i197.photobucket.com/albums/aa271/shrekb18/7.jpg?t=1186509214
http://i197.photobucket.com/albums/aa271/shrekb18/5.jpg?t=1186509239

2

Start calling junkyards. That hub was used on multiple models of Hondas so you might get lucky and be able to scavenge one for cheap.

3

[quote=“Rx3,post:2,topic:33552"”]

Start calling junkyards. That hub was used on multiple models of Hondas so you might get lucky and be able to scavenge one for cheap.

[/quote]

I have a few leads, I wish I never got into this, should off just let HC deal with it once the car was running. So EG hondas and DC tegs used the same parts right?

4

OOOOOhhh balls. Call us if you need anything.

Don