I’m going to be using one of these on the Miata.
It looks like they have two barb fittings on the outlets (feed/return,) but the inlet fitting is pretty funky looking, and I’m assuming it’s a GM piece.
Any adapters to adapt this threading to some other, preferebly barbed, fitting?
I’m not sure about adapting the fitting, sorry. But just FYI (I assume you already knew this) the filter is also the pressure regulator.
-TJ
TJ,
yea, thanks for the heads up, but I did know that. That was actually why I chose to go this route instead of the Aeromotive I have laying around. It’d be easier to run the return back to the tank with the Corvette setup.
Jesse
Check in LS1TECH under conversions and Hybrids, they have part#'s for those fittings, I think it is a Sticky in that section
K, thanks guys. I’ll check it out later.