Shaving Zenki OEM bumper

[i-Drift]

@smp-16

So I’m planning on shaving my S14 Zenki bumper so that there are no front turn signals and no middle “cross” so it will open up where the intercooler is a little more .

Now will fiberglass bond to urethane properly or should I use something else?

Has anyone done this and did they just wire their front bumper signals so they make the corner lights blink instead?

nothing bonds to poly urethane, try thick plastic pieces cut to size and Fuse them together with a hot stick. then when it dries sand and use bumper repair type of bondo.

it will work but its alot of work and dedication.