Like its bolted in solid, But maybe are the IC pipes too long on the one side and I could cut it down an inch or two then refit or is there something else I can do. Cause from far away having it look crooked is pretty darn fugly.
You could try just forcing it into position and securing it somehow with brackets/etc. Or just spray it black so noone notices lol.
Longer silicon couplings may alow a bit more movement as well.
you will probably have to get rid of some of the brackets holding the ic in right now, but on the pipe in the picture, cut that pipe in half pretty much right where it sits behind the signal light. Then just add a silicon coupler between the two pipes that you just cut apart, and that should give you the couple inches you need to make it straight.
hope that helps as an easy solution. If the pipe has an aggressive bend though, the coupler might not be the best idea.
http://www.n-e-c-c.com/forum/viewtopic.php?t=2204
Have a look at the picture I posted here. I made the intercooler brackets for this. It was easy as hell. Took no time at all. What I’m getting at is, make your own brackets or modify those ones. Then screw around with making the pipng fit once the intercooler is mounted good and solid again.