who can mill something for me?

PittSpeed Automotive
1

i have an ABS sensor ring installer i found at work. problem is i found it over with the press tools. it’s pretty much a steel cylinder about 3.5" in diameter and 6" in length

the edge of it (where it would rest against the ring while hammering it on) is all chewed up. i tried grinding it down a little but i’d like to to be flat and level across the entire surface

does anyone know someone who could mill this down for me?

whoops wrong section :crying:

2

what do you want it made of, do you want me to just re -face what you have??

3

yeah. forget about it. i basically wanted to cut down the cylinder a little bit to get it level again.

i don’t think i’m gonna bother with it. it aint like it’s something i’ll use every day.