If it doesn’t go behind my small block it will go behind an lsx block.
Pm me.
ALF. HA!
PM @cougarspeed
I tell him to sell me one all the time.
Just buy his spare motor/trans setup lol then pro-touring, mhmmm.
<333
You need an LT1 t56 for an sbc / bbc
Ls1 is for ls1 based blocks including the LQ’s I believe
The lt1 t-56 is a bolt up option for later SBCs. I have a two piece rear main seal and would end up spending 400 on a flywheel to run it. This stopped me from throwing one on last year. With plans on going fuel injection down the road I didn’t want to have an lt1 t-56 around when I do pull the motor.
I’m going to run McLeod apapter 8207.
You can get a flywheel from a 70s truck and use the proper sized clutch… that’s what I did on my 2pc.
Mine was internally balanced so it was easy mode. I know someone with a couple ls1 t56s ill give him a call
No shit…That would have been great to know last year.
Lmk about that contact. Thanks
How much you want to spend? I could part with my liberty faceplatted one with custom gears for the right money.
Was aiming for the 1400-1800 range.
You can come visit mine in the basement any time. 
http://rochester.craigslist.org/cto/4398603993.html
Sick deal, buy and part out you’re welcome
Emailed him twice and nothing.
But thanks for the heads up.
oh well would have made money on that one. Keep your eyes open you’ll find one.
Yep, I emailed 3 times too