WTB Rear License Plate Light Assembly

I need one in working condition, mine has fubared scews that I don’t think I can get out. If anyone is parting out a car, I will buy thuds off of you.

is it a hatch and are you talking about the rebar? if so i have a coupe that needs a rear rebar so i can put the bumper i have on it two pm me plz

It’s the sheet metal bar that holds on the two license plate lights. I need that assembly because my screws are faucked, unless I can find a way to get them out.

if you can use an s13 one come by my house.

I dont think the light bracket is fastened to the rebar. Its just screwed into the urethane bumper but you need to take off the bumper/rebar to be able to access it. For S13 hatch/coupe that is

Devin is right - there are 3 3/4" philips screws fastened into plastic retainers - if the heads are messed up just use pliers to turn them out. This way you remove the whole bracket with the lights . You can remove this on a warm day without removing the bumper by bending the urethane tabs and sliding the bracket over. I have made replacement brackets from sheet metal but it is a bit of work . Most of these brackets located here have rotted and removing either light usually results in more damage. You can get really good condition ones from wrecking yards down south and both coupe and hatch. use the same bracket.