Need to make (3) 90* bends and (3) 22.5* bends in some 1.5" OD exhaust pipe for a bike I’m putting together…I have a 12 ton pump-action pipe bender from Harbor Freight but it simply is not suited for thin-wall tubing like this so I need a quality machine to do this…I would be bringing (6) pieces 12" long to bend real quick like and get out of your hair. Can swap beer for your trouble or something…
are you sure the bends can be accomplished with such a short section to hold on to? what I’ve seen requires a fair amount.
It will prolly need to be longer. I wouldn’t cut the 10’ length yet. Bend one then cut, and so on
Txt me. I have a Hook up to a roll bar machine. It might be useful
I think you’re going to have a hard time bending exhaust tube in even a draw through bender. Why not just buy a few J bends?
theres a mandrel at my shop