FS: 300zx Rear brakes

Hey,

I have a set of 300zx rear brake calipers and rotors.

The calipers look to be in good condition. The rotors are rusty due to sitting in the garage for a couple years. I was just too lazy to install the rears. All you would need to do is machine them.

Make me an offer. I’m thinking around the $300 mark???

http://www.n-e-c-c.com/aaron/Z32rear1.jpg
http://www.n-e-c-c.com/aaron/Z32rear2.jpg
http://www.n-e-c-c.com/aaron/Z32rear3.jpg
http://www.n-e-c-c.com/aaron/Z32rear4.jpg

This is a little bit of a project for the S13. Here is a write-up on how to install them: http://importnut.net/300zxbrakeswap.htm

Enjoy!

What? No one wants to be a pimp. Seriously, just make me an offer.

If you dont have the Z32 uprights than its kinda hard to swap those brakes. You could swap them but you wouldnt have an EBrake.

You dont’ need the uprights. And the ebrake can be modified. Its been done time and time again. Just takes a lil’ time.

You need the 300zx ebrake cables, and the 300zx splash sheild setup.

Hmm… I might be tempted to buy just the calipers from you, to use as cores for getting them powdercoated.

Hmm…

So, since the car is up for sale, its time to get rid of the brakes too.

$200