I need a handle bar mount for a a/f gauge. Handle bars are 1.125"thk.
Any ideas on where I can find one.
I could make one…what size gauge? 2&1/16" ?
yeah 2-1/16
This is what Im talking about. This is for 1.5" tubing, I need something for 1-1/8 . Could use that and use rubber to make of for the size difference.
^did you mean to put a pic in that post?
do you need the gauge to mount parallel with the bar as that pic shows, or perpendicular to the bars? or does it need to be adjustable?
That one is on a ball mount so it will swivel 360 degrees. It will allow the gauge to be perpendicular to the bars. Think im going to try that one, use some rubber hose around the bar to take up the difference and help with vibration.
---------- Post added at 12:30 PM ---------- Previous post was at 12:06 PM ----------
Can you weld stainless steel? I need a O2 bung installed.
I’m in the process of getting setup for stainless…