That’s only about an hour and half right now, I just stumbled across some videos on youtube about it.
I used 4 images from a “blue print” front, rear, side, top and did the 3D sketch and then surfacing.
I was using a really low res print that was tough to work with but I just wanted to work through it and see what was what. Hopefully now I can find some higher res. images and start from scratch knowing what I’m doing from the start.
BTW, I hunted all over today for that alternator, I think I dropped it off with synapse with my motor. Next day that they are open I’ll drop in and pick it up.