[quote=“Nikuk,post:702,topic:22123"”]
I would’ve rather seen oval tubing, and you’re going to be using alot of wrap (i would imagine). Then again, it’s your pocket 
Considering that you will most likely sell the car, did you put any thought into ease of removal (DP)? With a doghouse welded over it all, i cant imagine it being very easy to remove that DP.
:gotme:
:tup:
[/quote]
Newman and I were just discussing this yesterday. The downpipe isn’t fully done yet as it is missing a vband disconnect at the last 45 shown inside the car and a flex section. But welding the dog house fully in was discussed. Newman is making a new dog house that covers all cut out parts up to the old blower box inlet(now used as an exhaust inlet). This doghouse design will allow downpipe removal without removal of the cover.