NTBorrow: honda ball joint tool

[ninety1two40]

@Boxersix

Sometimes you can get them out buy using a two jaw puller and a deepwell socket that fits over the stud to reach the body. jaws wrap around the backside of the knuckle near the BJ body, center bolt presses against the socket to force the balljoint out of the knuckle.

Doesn’t always work, but most of the time it’ll pop them out. Essentially does the same the the factory tool does.

oh and it should be a rigid beam puller, not one that the arms piviot all around.

like this one

I have one at the garage you can borrow if I get it back asap.

Never seen that style puller before, I like that!