wheres the best place to install alky/meth nozzle ? intake manifold, charge pipe, or pre compressor?
nevermind i figured out where im gonna put it.
Pre-TB.
yea, thats what i figured. thanks
Depends on how your particular injection system is built, and how you intend to use it. Most kits are setup single nozzle, mass spray, and are best suited at least 12" before the throttle plate. If the motor has a complex curve plenum/runner injection fluid can pool and it’s then best to run multi nozzles post TB, but you must incorporate check valves and/or anti-syphon solenoids and related circuitry…
yea im not going to do all that, just one in the charge pipe should be fine, nothing crazy just let me keep a little more timing.
Sounds like a waste if all your going to do is a bit more timing unless it’s purely safety?
def not a waste of time…