Everything was fine and the seal got torn somehow . car was fine , Been doing a lots of adjustment trying to get the motor at TDC from the crank and it started with drips now its leaking oil, and it’s comming from behind the pulley.
According to the fsm the front engine cover needs to come off . Can someone confirm that this can also be done on the car by just removing the crank pulley ? I might as well upgrade to an underdrive lightweight pulley .
Bruce , I should have listened to you :lol:
is this an sr? if so if you have to take the front cover off its alot of work in the car but it can be done. you have to take the oil pan off and the bigger aluminum part off to take the cover out. you should alos check your pcv system to see if its plugged that can cause a seal to leak because its under pressure.
ka24de . I got the answer anyway , 10 min job if you have a crank puller available .
I will borrow the tool and do it nect weekend .
ya i have done a buch. pull the rad. take off the belts and then pull the crack pully off. i used impace to get it off… pull the seal out with screw driver but try not to scrach anything.
hammer the new one in strait with rubber mallet. and have a good day.