woooowwwwww, pj did NOT put that skull mirror in there lololololol
dibs on the scull mirror.
Skull mirror is free for the taking lol
Hitch and wiring added. Taking it over to my buddies this week to figure out a rear bumper so I can ditch the roll pan. Bumper has to be pretty slim and fixed to the frame for the tilt bed so its a little tricky.
i think you were able to make very nice deal… Truck is in very good condition and little modifications will make it perfect… Congrats
ordered oem cats
Fixed the tow/haul today
Fixed the hood release
Put news straps on the tailgate
Replaced the vent visors/window visors
Removed the LEDs from the front grill
Removed the Sirius radio
Added a billet fuel door
Taking it over to Kenny tonight to get a remote starter and keyless entry
You should have him setup the remote to control the dump bed too
it’s hydraulic (I want to convert to electric hydraulic valve)
dump is awesome.
(waiting for benny to comment on my reply…)
So what does the dump bed run off of? Like how do you make it dump?
you pull or push a lever
just saw this thing in person, looks good
Thanks
Haha… I was actually looking over the setup yesterday to see if it was hydraulic or electric/hydraulic to see if it would be possible to run by remote… lol. The actuators took a little longer than expected (tight squeeze and not a lot of options for attaching to the factory lock rod). But they are in and wiring run. Tonight I should be able to finish everything up. I must say, it’s quite nice being able to stand to do a remote start and not have to twist all around to fit under the dash… lol.
Haha. I was under the hood the other day and needed to stand on top of the tire to see
very excited to get a keyless entry 
Yup, when it comes time for the hood pin (for the remote start), I’m almost positive I’ll be getting the ladder out… lol