Wheel spacing question?

NYSpeed Automotive
1

Hey guys.

As you may know I’m putting a BBK on my CRX. This kit required the rotors to be spaced out 3mm from the hub. Therefore I’m running a 3mm spacer(This is mandatory).

However I ran into a problem upon mock up. I need an additional 4mm of clearance between the wheel and the rotor(Caliper hits my wheel spokes).

My question is, can I run technically 7mm spacers upfront without running anything in the back?

Mind you this car will never see anything more than DD driving when it comes to twisties.

2

yeah you dont have to have the same width in the rear… it may look a little goofy but it shouldnt cause problems.

you should run longer studs though and make sure the wheel stays concentric to the hub.

Brian

3

this man knows hip hop. 7mm isn’t much at all. people run wayyyyy bigger spacers.