Well I’m going to be rebuilding a turbo and swapping some housings around soon and I was looking for somewhere local to get it balanced. I would hate to ship it out just to get it balanced.
Somewhere close to Monroeville/Greensburg/Indiana would be awesome.
Thanks guys!
Nearest place that I am aware of, did my 60trim, never had problem after.
No shit? how much was it and how long did it take?
Dropped it off early in the week, had it done by the end of the week. This was over a year ago it was around 60 bucks. All you need to give them is the compressor wheel and the turbine wheel/shaft. They mark what position to place them in when you assemble the turbo. If you feel really scared, Im sure they will take care of the assembly/disassembly for a couple extra bucks.
Bolland Machine… i take all my big boy turbo’s to them and send the little ghey ones out.
Thanks for the suggestions guys! Gateway is about 30 minutes away which isn’t too bad. Nice to know 
Ahh. I figured you would just give them the whole center section and they would spin balance or something and you would just throw on the covers and go. seems like you could still screw it up putting it on yourself if its the slightest’s bit off since they spin at hundreds of thousands of rpm’s.
Where is that shop at gearhead?