Where to get steel mandrel bent?

[jcxcr4000]

@czwalga00gt

I’m on the east side of pittsburgh, new kensington area. I fabbed up a roll bar out of PVC pipe for my ls2 rx7. I need to get the pipe mandrel bent to my specifications. I’m looking for a place to do this anyone know of anyone who does this?

It doesn’t even need to be notched, just bent. I’ll actually probably have them cut the steel an inch or two longer than its supposed to be so I have room to work. I just cant afford to purchase a $20k mandrel bender just for a roll bar.

hey whats going on man this is joel from up at ntb in lower burrell i was talking to you a few weeks ago