Strange question, I know… but is there any place I can take a rim into and get the width/offset measured?
- Mike
measuruing tape in your living room lol.
lol, well yeah I think I can measure the width myself, but the offset is a little tricky.
- Mike
Lay the tape measure across the wheel measuring the width, and then place a straight edge on the mounting hub of the wheel and have it touching the tape. Then just measure your width and offset. Super Easy!
http://www.rsracing.com/tech-wheel.html
stop by kal tire and ask for them to meaure it … it takes two seconds and they have a little key ring with offset “keys” just goes from hole to hole and tells you…
What is tricky is figuring out bolt patterns, no?
No. Use a straight edge across two holes. Measure across to the middle of them.
Not so fast smarty pants. Even # of holes easy as there are opposites. Odd number of holes WTF? Five holes…the holes are not equidistant.
yes just pick two that are going to give you the furthest measurement. I guarantee they will all be the same.